Hatch in een geprojecteerd iso zicht van een sectie activeren...

Aan de titel alleen al zult u denken van "Wat is dat weer?".
Nu dit komt rechtstreeks uit de Knowledge Base:

Activating hatch in a projected iso view of a section view (IV11)

Oplossing:

To activate a hatch in a projected iso view of a section view

1. Create the section view.
2. Create an iso view of the section view.
3. Create a temporary sheet in the same IDW file. Drag and drop the
iso-section view from Sheet: 1 to this temporary sheet.
4. In the temporary sheet, create a detail view for the section view.
5. Drag and drop this detail view from the temporary sheet to Sheet: 1.

You can now switch on/off or change the properties of the hatch pattern in the detail view. These hatch properties will sustain any changes to the model/assembly.

Je moet er maar opkomen!